To change the batteries of the thermostat of a Honeywell thermostat:

Silky Terrier Dog Breed Playing Aro...

To view this video please enable JavaScript, and consider upgrading to a web browser that supports HTML5 video

Silky Terrier Dog Breed Playing Around

Shut off the power source to the circuit breakers

Take the battery compartment off the baseplate

Take out the batteries from the old ones.

Replace the batteries

Install the new battery compartment on the baseplate

Power on the circuit breaker in the circuit breakers

Thermostat batteries often end up dying at the wrong moment. There’s a hot day following a cold snap and then reduce the temperature, only to discover… the batteries go empty. Then you experience some unexpectedly cold weather days at the end of summer. You turn up the thermostat, and… again, the batteries are dead as an old doormat.

Don’t worry! In this article, you will find the best guideline. Honeywell thermostat. It is perfect for replacing an existing thermostat using either the pull or hinge design.

#1 Turn the Power Off

Before you begin to crack ensure that you turn off your thermostat. The thermostat has an on/off switch on the front that you may use to turn it off. This will prevent the thermostat from syncing itself in the event of a malfunction after you take the batteries off.

Then turn off the power at the thermostat circuit breakers.

#2Detach the Baseplate from the Battery Compartment.

The steps will vary based on what model you have of the Honeywell thermostat. Look over the table below to provide you with the procedure that’s appropriate for your specific model.

#3 Discard Old Batteries

Remove any occupied batteries from the faceplate.

Note down the size of the battery that was used previously. After that, dispose of the batteries.

#4 Replace the Batteries

Replace the batteries that are old with brand new ones. The majority of Honeywell thermostats require two AAA batteries. However, to ensure your safety you should replace your batteries with the same size as were present before.

#5 Reinstall the Battery Compartment

The steps will vary according to the model of the Honeywell thermostat.

#6 Turn the Power On

Begin by switching the power back on by the circuit breakers. Then, turn on the thermostat by pressing the button on or off. Then wait for a new cycle to appear on the screen. After about a minute the thermostat will re-start and is ready to use once more.

ncG1vNJzZmijqaG8r7zOsJylpF6YvK57x6iuZqyfYrCprc2gnGaakanBpr7YZqCnZZiku6bF1p6jpWWkpMKktNKcqZ6dnmLBqbHRpqasrJGpfA%3D%3D